/23
PAIRING / SYNCING THE REMOTE
1. Turn the skateboard on.
2. Turn the remote on.
3. Press and hold the MODE 1 BUTTON on the remote for one
second or until the Bluetooth symbol begins to ash.
4. Once paired, the Bluetooth symbol will switch to a solid
symbol and the battery display will show a reading. This
means you are ready to ride!
NOTE – ONCE THE REMOTE AND BOARD ARE SYNCED TOGETHER, THE NEXT
TIME YOU USE YOUR BOARD IT WILL AUTOMATICALLY SYNC. THERE ARE ALSO
BARS NEXT TO THE BLUETOOTH SYMBOL TO INDICATE SIGNAL STRENGTH.
TIP – Make sure not to touch the acceleration or brake triggers
as the remote is pairing to the board. Once paired, lift the
wheels off the ground and accelerate. Then brake to test that
the control is clean and smooth. If there are any delays in the
control, turn both the board and remote off and retry the above
process.
ON / OFF
ON / OFF
x1
1 Sec
x1
175mm
Trip:
0.0 km
km/h
66T
90%
0
1 2 43
MODE 1
To Next Page
Loading...