/44
If ever the board experiences an operational issue, an error
message will be detected by the remote and displayed in the
‘More Info’ screen.
See below the list of Error Codes:
‘BATT ERR’
This error code may be displayed if there is an error in
communication between the BMS and motor controller. In the
event this occurs, the board will limit the speed mode to SAFE
MODE to reduce the risk of damage to the battery.
‘MAINTAIN BATT’
This error code may be displayed if a cell in the battery is
detected as being ‘out of balance’. In the event this occurs, the
board will limit the speed mode to SAFE to reduce the risk of
damage to the battery.
‘MOTOR # ERR’
This error code may be displayed if an error has been detected
from one, or both, of the motors in operation. The error will
indicate ‘Motor1 Err’, ‘Motor2 Err’ or ‘Motor1&2 Err’.
IF EVER THE BOARD DOES EXPERIENCE AN OPERATIONAL
ISSUE, PLEASE CONTACT YOUR LOCAL EVOLVE SKATEBOARDS
SUPPORT TEAM FOR ASSISTANCE.
ERROR CODES
To Next Page
Loading...