/42
• If you accidentally press both the accelerator trigger and
brake trigger at the same time, the brake function will work
and cancel out the accelerator.
• If you hold down the accelerator and brake triggers then let
the brake trigger go it will not accelerate.
• As you are riding and holding down the accelerator or brake
trigger, you will not be able to change speed modes or turn
the remote off until you let the triggers go.
• When the Safety Switch is enabled and you kick push the
skateboard to start, you can avoid pressing in the Safety
Switch, this is also good for battery efciency.
• Get to know the vibration warnings on your remote, these
can be useful during your ride.
• The LCD screen is much easier to see when there is less
direct sunlight.
• The R2 remote will turn off after 5 minutes of non use to save
on battery life.
• Avoid riding with your thumb positioned on the brake trigger
as you are accelerating, this may cancel out the accelerator
when you are not ready for it
OTHER REMOTE OPERATION FUNCTIONS
AND TIPS
To Next Page
Loading...