EVS XT Series - Digital; Analogue Monitoring; Digital; Analogue Signal Loop; Ohm Termination

XT Series DISK RECORDER - Technical Reference
EVS Broadcast Equipment SA - Nov 2005
Issue 3.0
30
4.2.1.3.2 Digital / Analogue monitoring:
Moving the MON_A and MON_B jumpers allows you to select analogue or
digital monitoring from the Monitoring outputs BNC connectors on the rear
panel.
MON A / B:
The corresponding monitoring output from the rear panel is analogue.
Adding chips to U79 and U77 first,
then move MON A /B jumper to this position:
The monitoring outputs from the rear panel are digital.
4.2.1.3.3 Digital / Analogue signal loop:
Moving the LOOP_A and LOOP_B jumpers allows to select analogue or
digital input loop (IN1, IN2, IN3, IN4, IN5, IN6) from the BNC connectors of
the rear panel:
LOOP A / B:
The signal loop from the rear panel is analogue.
LOOP A / B:
The signal loop from the rear panel is digital.
4.2.1.3.4 75 Ohm Termination:
ST10 jumper has to be set on HIZ position
!
Important note: In all configurations, SPARE SIP resistor has to be removed. First
releases of LSM-XT were delivered with this resistor, the next releases are delivered
without the SPARE SIP resistor.