EasyManua.ls Logo

EVS XT Series - Time Calibration and Hardware Checks; Hardware Check and RAID Rebuild

EVS XT Series
49 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
XT Series DISK RECORDER - Technical Reference
EVS Broadcast Equipment SA - Nov 2005
Issue 3.0
6
18” Touch Screen Video Monitor
Weight: 11.0 Kg / 23.9 Lbs.
Keyboard - Weight: 0.4 Kg / 0.9 Lbs.
Tablet - Weight: 0.5 Kg / 1.2 Lbs.
Ref: Wacom® GD0405R
2.3 Installation
Verify the Disk recorder unit has the correct voltage specifications
for your power source prior to applying power.
(selectable 110/230 VAC on the rear panel of the power supply, or autoswitch,
depending on the type of power supply unit installed)
Main power switch is located at the front side (lower righ corner) of the unit.
Before turning on the power, open the front door of Video disk recorder
unit to check if all boards fit into their guides. If a board is out of its
guides, remove carefully the board and replace it in the same slot.

Table of Contents

Other manuals for EVS XT Series

Related product manuals