EWM Phoenix 405 Progress puls TDM - Resetting Welding Jobs (JOBs)

Rectifying faults
Resetting JOBs (welding tasks) to the factory settings
44
099-005320-EW501
22.05.2014
7.3 Resetting JOBs (welding tasks) to the factory settings
7.3.1 Resetting a single JOB
NOTE
All customised welding parameters that are stored will be replaced by the factory
settings.
EXIT
RESET
ENTER
3 s
3 s 3 s
JOB-
LIST
JOB-
LIST
Figure 7-1
Display
Setting/selection
Reset to factory settings
The RESET will be done after pressing the button.
The menu will be ended when no changes are done after 3 sec.
JOB-number (example)
The shown JOB will be set to ex works.