EWM Taurus 355 Basic TDM - Welding Task Selection; Accessory Components for Operating Point Setting

Design and function
MIG/MAG welding
099-005221-EW501
16.04.2014
37
5.11.2 Welding task selection
NOTE
Selection of a welding task involves the interaction of the controls on the welding
machine and the wire feed unit. After the basic settings are made on the welding
machine, the operating point and other parameters can be set on the wire feed unit.
1
4
15
50
10
20
25
35
40
45
30
2
3
0,5
1
1,5
2
2,5
3
3,5
4
5
6
7
8 9
10
11
12
13
14
15
16
18
20
22
24
m/min
Figure 5-14
5.11.2.1 Accessory components for operating point setting
The operating point setting can also be made with the accessory components
• R11 / RG11 remote control
• Up/Down torch with two rockers (2 U/D)
You will find an overview of accessory components in the "Accessories" chapter. See the operating
instructions for the machine in question for a more detailed description of the individual machines and
their functions.