EXCELL PRECISION CO., LTD.
0201810X ZSME300000292
Unit Weight Too Small ( ) Unit weight is less than 0.2 division.
(0.1 d for Brazil regulation)
When sampling, the above two symbols indications are on. Under such conditions,
the scale can still work, but may result in lower count precision.
When using 2-segment weighing mode, the above two symbol indications change to
Range 2 and Range 1 and the two symbol indications are off.
2-3-2 Check Weighing
Refer to the operation of check weighing in weighing function.
2-3-3 Totalizing
Refer to the operation of totalizing in weighing function.
Chapter 3 General Function Setting
Switch on the scale. While the scale is counting down to zero, press and hold key
until
the display shows the software version number 02018. Release the key, the
scale enters into the configuration setting mode and display F0.
key ⇒ upward key
key ⇒ downward key
key ⇒ to confirm
Check Weighing Configurations
RS232 and Mini Printer Output
Setting (option)
Internal Value Display Mode
Print Key Function Setting
Customized Header Setting
(r n P 6, r n P 7)
F0~F3, F9, F10, F13, F15 are reserved.
To Next Page
Loading...