EXCELL PRECISION CO., LTD.
0201810X ZSME300000292
beeper beeps.
Under Status in Preset Low Limit (preset single point only)
The BEEP, LCD mode should be fixed as follows:
When over “Low Limit”, the beeper beeps and is off
Whether stable or not, the beeper beeps and LCD indication is on
Warning device setting
Set HI value and value of the beep, LCD mode should be fixed as follows:
A
When the weight equals to HI value, Relay Card open and the weight is accumulated.
Press CE key to dismiss the warning sound and the range of accumulated weight is
[000.000]~[999999].
Clear warning accumulation
Press key first and then press key to clear all accumulated data.
Accumulated data is cleared automatically under in following conditions
a. when shift among weight mode, counting mode and warning accumulation mode.
b. when shift the units
c. turn off the scale
LCD indication:
10d Low Limit High Limit
◆ To exit preset mode, please press key.
2. Recall Check-weighing Values
Press key then press key
Recall “Low limit value”
Then press key again
Recall “High limit value”
Then press key again
Recall “Beeper value”
Then press key again
Back to the beginning
3. Clearing Check-weighing Values
Press key then press key, and then press key
Recall “Low limit value”
Then press key again
Clear “High limit value” and “Beeper value”
Press key then press key 6 times continuously
Clear all values.
2-2-5 Totalizing
1. Weight Totalizing
Place goods on the platter, after stable and press key to save the weight value.
Then the display shows the total number of additions and the totalized weight value.
And the (M+) indication “
” will flash on the display. The indicator will recover to show
To Next Page
Loading...
Need help?
General
