Excell FB530 - F6 Exit Function; F7 Internal Value Display Mode; F8 Weight Hold Mode Setting

EXCELL PRECISION CO., LTD.
0201810X ZSME300000292
19
5. Press key to restart the printer.
3-3 F6 Exit Function
Use or to select F6. Then press to count down to zero and exit the
setting.
3-4 F7 Internal Value Display Mode
Use or to select F7. Then press to display internal value. Press
again will see F7.
3-5 F8 Weight Hold Mode Setting
Use key or key choose F8
 Before setup, please switch the SWA1 on
MINI JUMPER to ADJ position
 After setup, please switch the SWA1 on
MINI JUMPER back to LOCK position
 In hold mode, press key, to print the
hold value as shown on display.
(It’s not related to the settings of F5
transmission mode, but it needs to select the
proper Baud rate according to the
transmission of the receiver.)
(To setup transmission rate, please refer to
F5 RS-232 Interface Output Setting (option))
Use key to select a value from hold 0 ~
hold 5 and then press key to complete
setup.
Press key Press key
Press key Press key
Press key
Press key
good word space
word space too low
please adjust it to a higher value