EasyManua.ls Logo

EXE Rise - Controller

Default Icon
80 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
USE AND MAINTENANCE MANUALUSE AND MAINTENANCE MANUAL
Chain hoist from 198kg to 2500kg
55 CONTROLLERCONTROLLER
5.15.1 INTRODUCTION AND COMPATIBILITYINTRODUCTION AND COMPATIBILITY
To power and control EXE RISE electric chain hoists, it is recommended to use EXE DRIVE Motor Controllers.
Depending on the model, these control systems are designed to handle groups of up to 4/8/16/24 EXE RISE
electric chain hoists.
The number of hoists that can be simultaneously operated with the control system defines the maximum number
of machines that can handle a multiple lift.
DANGERDANGER
Do not connect the hoist plug directly to a power outlet but use a control system that meets the minimumDo not connect the hoist plug directly to a power outlet but use a control system that meets the minimum
requirements as specified in these instructions.requirements as specified in these instructions.
WARNINGWARNING
The control system must be installed by competent personnel.The control system must be installed by competent personnel.
Before powering the EXE RISE electric chain hoist, it is necessary to check its compatibility with the EXE DRIVE
Motor Controller control system, as summarised in the following table.
MOTOR CONTROLLERMOTOR CONTROLLER
EXE DRIVE EXE DRIVE
SMALL SMALL
MEDIUMMEDIUM
COMPACTCOMPACT
MEDIUMMEDIUM LARGE 1FLARGE 1F LARGE 2FLARGE 2F
EXTRA LARGEEXTRA LARGE
EXTRA LARGEEXTRA LARGE
COMPACTCOMPACT
EXTRA EXTRAEXTRA EXTRA
LARGELARGE
DH1DH1
VV VV VV VV VV VV
DH2DH2
VV VV VV VV XX XX
XDDL4 XDDL4-LVXDDL4 XDDL4-LV
VV VV VV VV VV VV
XDDL6XDDL6
VV VV VV VV VV VV
XDDL8 XDDL8-LV XDDL8 XDDL8-LV
VV VV VV XX XX XX
XDDL16 XDDL16-LV XDDL16 XDDL16-LV
VV VV VV XX XX XX
XDDL24 XDDL24-LV XDDL24 XDDL24-LV
VV VV VV XX XX XX
XDDB4 XDDB4-LV XDDB4 XDDB4-LV
VV VV VV XX XX XX
XDDB8 XDDB8-LV XDDB8 XDDB8-LV
VV VV VV XX XX XX
XDDC4 XDDC8 XDDC4 XDDC8
VV VV VV XX XX XX
EXE RISE electric chain hoists are designed to be used with EXE DRIVE Motor controllers; however, they are
compatible with any control systems that meet all of the following minimum requirements:
LLaanngguuaaggee:: EENN MMaannuuffaaccttuurreerr:: RRWWMM SS..RR..LL AAuutthhoorriisseedd rreepprreesseennttaattiivvee:: AARREEAA FFOOUURR IINNDDUUSSTTRRIIEESS IITTAALLIIAA SSRRLL
32

Table of Contents