USE AND MAINTENANCE MANUALUSE AND MAINTENANCE MANUAL
Chain hoist from 198kg to 2500kg
DANGERDANGER
Do not operate the hoist if the power and/or control cable and relative cable glands are damaged.Do not operate the hoist if the power and/or control cable and relative cable glands are damaged.
Before connecting the hoist to electrical power, check that the voltage and power of the power line correspond to
those given in this manual and/or on the identification plate, and check the efficiency of the grounding system of
the installation site.
Check that the cables powering the hoist are protected against external damage.
Uniquely identify the power and/or control cables of the hoists before connecting them to the motor controller in
order to assign them the relevant channels on the control panel.
6.36.3 PRE-USE CONTROLPRE-USE CONTROL
WARNINGWARNING
Before installing the machine, perform the pre-use checks as defined in these instructions; if these checksBefore installing the machine, perform the pre-use checks as defined in these instructions; if these checks
fail, do not use the hoist!fail, do not use the hoist!
WARNINGWARNING
Install EXE RISE electric chain hoists that have been subject to regular inspection and maintenance asInstall EXE RISE electric chain hoists that have been subject to regular inspection and maintenance as
defined in these instructions!defined in these instructions!
Pre-use checks must be carried out before operating the hoist at a new installation site.
These pre-use checks are visual and logging them is not mandatory.
If pre-use checks fail, do not operate the hoist and ensure it is inspected, maintained and repaired, if necessary.
The minimum pre-use checks are given in paragraph 7.
WARNINGWARNING
Do not install the electric chain hoist in a position where the chain, hoist frame and bag can come into
contact with external bodies!
WARNINGWARNING
Make sure that the chain stop does not come into contact with the frame of the machine! In case of
accidental contact of the chain stop with the frame, operate the hoist by reversing the direction of travel so
as to remove the stop from the body.
6.46.4 CONNECTION TO THE ANCHOR POINTCONNECTION TO THE ANCHOR POINT
WARNINGWARNING
Before installation, check that the lifting and set up operations for the suspended loads have been properlyBefore installation, check that the lifting and set up operations for the suspended loads have been properly
designed and planned!designed and planned!
DANGERDANGER
Before installation, check that the anchoring points and/or their suspension points have been properlyBefore installation, check that the anchoring points and/or their suspension points have been properly
dimensioned in relation to the rated capacity of the machine and/or the actual suspended loads in use!dimensioned in relation to the rated capacity of the machine and/or the actual suspended loads in use!
Before connecting the EXE RISE electric chain hoist to the anchoring point, check that the latter has been properly
designed for actual loads in use and the intended lifting operations.
The hoist must be installed on the anchor point so as to be with the relative chain in a vertical position. The chain
must be sufficiently spaced from external bodies so as not to come into contact with them.
To Next Page
Loading...