USE AND MAINTENANCE MANUALUSE AND MAINTENANCE MANUAL
Chain hoist from 198kg to 2500kg
For D8 series hoists, once the suspended load reaches the working position, secondary safety devices shall be
installed in order to have a redundant suspension system from the anchoring point to the load suspension point,
as shown in figure 6.1.
figure 6.1 – "Safety Devices”
In case of multiple lift, ensure that all simultaneously controlled hoists are correctly connected to the control and
power supply system by tensioning each chain individually.
WARNINGWARNING
Before moving the load, notify the personnel in the area of installation and set up of suspended loads!Before moving the load, notify the personnel in the area of installation and set up of suspended loads!
WARNINGWARNING
Do not pull the suspended load diagonally or drag it horizontally across surfaces!Do not pull the suspended load diagonally or drag it horizontally across surfaces!
DANGERDANGER
Once the suspended load reaches the operating position, install secondary safety devices if required by theOnce the suspended load reaches the operating position, install secondary safety devices if required by the
intended use of the hoist and/or by local regulations!intended use of the hoist and/or by local regulations!
DANGERDANGER
Remove secondary safety devices before lowering suspended loads.Remove secondary safety devices before lowering suspended loads.
To Next Page
Loading...