USE AND MAINTENANCE MANUALUSE AND MAINTENANCE MANUAL
Chain hoist from 198kg to 2500kg
LARGE FRAMELARGE FRAME
1. Place the EXE RISE electric chain hoist in standard (fixed) mode.
2. Connect the EXE RISE electric chain hoist to an electrically compatible motor controller (see Chapter 5) and
run the chain up to the 16th-22nd link from its end (chain stop side). At the end, disconnect the hoist from the
motor controller.
3. Remove the chain stop with a 5mm Allen key.
4. Loosen and remove the screws of the outer plate with a 3mm Allen key.
5. Slide the outer plate up to the Chain hook block.
6. Remove the Chain hook.
7. Insert the new chain guide outer plate, making sure that the chain is perfectly tensioned.
8. Insert the Chain hook as detailed in paragraph 8.1.2 for a single fall, and in paragraph 8.1.3 for doule fall. The
roll pin must be replaced with a new one.
9. Slide the new plate to its site, making sure the chain is always in tension.
DANGERDANGER
If the chain is not perfectly tensioned, it will twist and the plate will not be able to be secured.If the chain is not perfectly tensioned, it will twist and the plate will not be able to be secured.
10. Secure and tighten the 4 screws with a 3mm Allen key.
11. Secure the chain stop with a 5mm Allen key.
To Next Page
Loading...