Introducing the EXFO EX1
EXFO EX1 7
Technical Specifications
RJ45 Port and LEDs
The RJ45 port is mainly used for testing the Ethernet network using an
electrical wired connection: 10Base-T, 100Base-TX, and 1000Base-T. It can
also be used to connect to the network for firmware upgrade (refer to
Software on page 41).
LEDs:
The LINK green LED is on when the link is up, off when the link is
down, and flashing when frames are transmitted and/or received.
The DUPLEX green LED is on for Full Duplex mode, off for Half Duplex
mode, and flashing when collisions are detected.
SFP and LEDs
The SFP port is used for 1 GE optical interface.
LASER red LED is on when the EXFO EX1 device is emitting an optical laser
signal.
LINK green LED is on when the link is up, off when the link is down, and
flashing when frames are transmitted and/or received.
Technical Specifications
To obtain this product’s technical specifications, visit the EXFO Web site at
www.exfo.com.
To Next Page
Loading...
