EXFO EX1 - Cleaning and Disposal

Maintenance
EXFO EX1 47
Cleaning LC Connectors
Cleaning LC Connectors
Under normal circumstances the cleaning of the LC connector is not
required. However if the connector shows signs of debris or
contamination, cleaning may be required.
To clean an LC connector
1. Use a clean dry air (CDA) or a air gun to blow out the dust or
contamination.
2. Re-inspect the connector.
3. If the connector is still not clean, use a commercial cleaner
recommended by the transceiver manufacturer.
Note: Refer to the transceiver manufacturer for more detailed cleaning
recommendations and instructions.
Recycling and Disposal
For complete recycling/disposal information, visit the EXFO Web site at
www.exfo.com/recycle.
This symbol on the product means that you should recycle or dispose of your
product (including electric and electronic accessories) properly, in accordance
with local regulations. Do not dispose of it in ordinary garbage receptacles.