EXFO EX1 - Interface Settings

Speedtest Settings
32 EXFO EX1
Test
Interface
Allows selecting the test interface and its parameters.
 Type/Rate allows the selection of the EXFO EX1 device test port to use
for the Speedtest: 10/100/1000M Electrical (default), 1GE Optical, or
Wi-Fi.
For RJ45 port:
 Connector indicates the port connector type which is RJ45.
 Auto-Negotiation indicates the state of auto-negotiation which is
enabled.
 Speed is set to Auto detection.
For SFP port:
 Connector indicates the port connector type which is SFP.
 Laser when enabled (default) activates the laser on the SFP
transceiver.
 Laser Off at Start-Up when enabled, disabled by default,
automatically turns off the laser when starting the EXFO EX1 device.
 Auto-Negotiation when enabled (default) advertises to the remote
port which parameters to use.
 SFP Information gives detailed information related to the transceiver
module.
 TX Power indicates the transmit power level in dBm.
 RX Power (Min/Current/Max) indicates respectively the receive power
level minimum, current, and maximum level in dBm.
 RX Power Range indicates the receive power range level in dBm
supported by the SFP.