EXFO EX1 - Page 42

Speedtest Settings
34 EXFO EX1
Test
To connect to an access point (when Not Connected is displayed):
1. Tap the setting button.
2. Enter the credentials to connect to this access point.
To disconnect from an access point:
1. Tap the setting button.
2. Tap the Connected access point.
3. Tap FORGET.
To change the access point:
1. Tap the setting button.
2. Tap the new access point.
3. Enter the credentials to connect to this access point.
To display the parameters of an access point:
1. Tap the setting button.
2. Tap the connected access point (SSID) to display its parameters (see
Wi-Fi on page 37).