Accessing Your Unit Remotely
Compact Modular Platform 155
Working with Remote Desktop
To access your unit remotely with Remote Desktop:
1. Connect both the computer and your unit to the same network and
make sure they can “see” each other as network restrictions might
prevent them from communicating.
If you want to use an Ethernet network, connect an RJ-45
(network) cable to the unit’s RJ-45 port located on its right side.
If you want to use a wireless network, see Connecting to a Wireless
Network on page 126.
You could also create a Private Area Network with your Bluetooth
device (contact your network administrator).
2. Turn on both the computer and the unit.
3. On your unit, in Compact Toolbox, go to Main Menu. Select System
Info > Platform.
4. Write down the IP address, and then close the window.
Note: It may take a few seconds before you see the IP address on the list.
5. From the computer, on the taskbar, click Start, then select
All Programs > Accessories > Remote Desktop Connection.
To Next Page
Loading...
