Test Results
MaxTester 283
Summary
Bit/Pattern Error Rate/Count graphically displays a meter
representing either the bit/pattern error rate or the bit/pattern error
count depending on the Pass/Fail Verdict selection
1
.
When the verdict is enabled
1
, the values under the threshold are
presented in green while the values above are in red.
When the verdict is disabled, the bit/pattern error rate is displayed in
blue.
The arrow pointer indicates the current received bit/pattern error
rate/count.
The Pass/Fail verdict is displayed just on top of the meter when
enabled
1
.
Bit/Pattern Error, Amount/Rate, and Inject: The bit/pattern error
injection and settings are coupled with the Inject Button on page 254.
For Transport test applications, not available in Through modes or with
Multi-Pattern.
Service Disruption
Note: Service Disruption results are only available with Transport and EtherBERT
test applications when Disruption Monitoring is enabled (refer to BERT
and Unframed BERT on page 78 or EtherBERT and Unframed BERT on
page 93). When Service Disruption is disabled, the message Service
disruption monitoring disabled is displayed.
Service Disruption is the time during which there is a disruption of service
due to the detection of defects.
To Next Page
Loading...
