Test Results
MaxTester 295
Summary (RFC 2544)
Throughput, Back-to-Back, Frame Loss, and
Latency Subtests
Throughput, Back-to-Back, Frame Loss, and Latency
For each subtest, its status (-- (Idle), In Progress, Completed, or
Aborted - (reason)) and duration are displayed.
TX Frames
1
and RX Frames
1
display the transmitted and received
frame counts of the subtest in progress. For Dual Test Set, frame
counts are available for both local (L) and remote (R) directions. For
Dual Port topology, frame counts are available for both port directions.
Trial #
1
displays the current trial iteration of the subtest in progress
when applicable.
Val. #
1
displays the current validation iteration of the subtest in
progress when applicable.
Step
1
displays the current step of the subtest in progress when
applicable.
Displayed Results: Select the displayed result mode: Current,
Minimum (default), Maximum, or Average.
Throughput/Back-to-Back/Frame Loss/Latency table.
Each frame size used for the test is displayed with its subtest statistics.
Statistics values are displayed based on the Displayed Results setting.
“--” indicates that the result is not available because the test has not
run yet. While testing, one of the following messages is displayed for
each frame size: Initializing, Learning, Testing, Waiting, Not
measurable, Aborted, Link is Down, or MAC not resolved.
Dir. (Direction), available with Dual Test Set or Dual Port topology,
indicates respectively results for both local (L) and remote (R)
directions, or for both port directions.
1. Only displayed once the test is started.
To Next Page
Loading...
