Expobar Diamant Pro - Machine Alerts; Display Messages and Alarms; Alarms Related with Grinding; Alarms Related with Boiler Filling

DIAMANT Pro
37
MACHINE ALERTS
Display messages and alarms
To alert users that routine service of the machine is due or against a situation that could possibly cause
damage to the machine, Diamant Pro has the following alerts programmed into its software:
10:05
Friday, 24 March
Cooler temp recommended
118 ℃
10:05
Friday, 24 March
Group cleaning overdue
118 ℃
10:05
Friday, 24 March
DIAMANT
118 ℃
10:05
Friday, 24 March
DIAMANT
118 ℃
10:05
Friday, 24 March
Flush short, flush again
118 ℃
10:05
Friday, 24 March
SmartSteam clean due
118 ℃
10:05
Friday, 24 March
DIAMANT
118 ℃
10:05
Friday, 24 March
DIAMANT
118 ℃
Note:
If one alarm is active, the warning icon ( ) will be shown in the main display apart from the
alarm in the ‘Name’ led.
If you press on the EXPOBAR logo area ( ) on the main display, you will enter the alarm
list where you can see the alarms enabled (in case there are more than one at the same time).
i
Alarm description
Alarms related with grinding
Alarm Description
GRX: Too ne
When the owmeter is measuring less than ‘ne grinding’ setting, this
alarm will be released.
GRX: Too coarse
When the owmeter is measuring less than ‘coarse grinding’ setting,
this alarm will be released.
GRX: Flowmeter
blocked
When the owmeter is measuring 0ml for too long.
Alarms related with boiler filling
Alarm Description
Filling timeout
If the steam boiler has been lling water for more than 180s, the
pump will stop and the display will show the alarm and the level icon
( ) will turn to orange.