28
G-10
R
PROGRAMMING
Programming the coffee dosage
This section explains how to program the doses dispensed automatically by the drink buttons.
Note:
Programming any of the options on the left-hand drink buttons (when viewing the machine
from the front) automatically sets the dispensing volumes on all of the other drink buttons.
This only applies to the left-hand drink buttons. Programming other drink buttons only
modies the option selected.
Important:
Use a porta-lter lled with fresh coffee for every new dose you program.
On machines not equipped with a display, hold down the Continuous Dispensing button for 4
seconds. On machines equipped with a display, hold down the Continuous Dispensing button for 8
seconds. The Continuous Dispensing button light will ash. On machines equipped with a display, all of
the Drink buttons lights will be turned on.
Press the dispensing option that you wish to program: 1 Short Espresso, 1 Long Espresso, 2 Short
Espressos or 2 Long Espressos. The lights on the button pressed and on the Continuous Dispensing
button will remain on.
The group will start dispensing coffee. When the desired volume is reached in the cup, press the selected
button again to stop dispensing. This volume setting will be saved. On machines equipped with a display,
the lights on the reprogrammed dosage buttons will remain off.
Repeat this process for all of the dispensing options that you wish to reprogram.
If you only need to reprogram one of the dispensing options, follow the steps above and program just that
option. All of the other dispensing options will remain unchanged (default settings).
i
To Next Page
Loading...
Need help?
General
