ZIRCON
16
Positioning
Install the machine on a level surface. Adjust the
feet to ensure that it dispenses coffee evenly in
all of the cups.
Select a level, dry, strong and stable installation
surface at least 110 cm off the oor.
Leave enough space above and behind
the machine to ensure easy cleaning and
maintenance.
Do not install the machine whilst wet or
damp. If wet or damp, leave the machine until
completely dry then ask service personnel to
check that none of the electrical components
are affected.
Note:
Leave an air gap of approximately 30 cm above the machine and 10 cm
behind it to ensure ventilation.
Delivery inspection
The machine is shipped in a unique carton box which uses expanded polystyrene paddings.
The machine box is provided with conventional symbols that can be perfectly visible during the
handling and storage tasks.
The machine box must stay in a vertical position during the transport. Do not tip or try to place the
box tilted sideways in any way.
During transportation the box must be protected from hits, impacts, shocks and exposure of bad
weather elements.
After the delivery, check that the machine is in the exact condition described in the documentation of
the transport, accessories included.
Check that the machine does not have any damage caused by transportation. If this happens, inform to
the shipper and the distributor of the machine.
The packaging materials are potentially dangerous and should be kept away from children.
Make sure to leave the materials of the box and packaging at a suitable recycling center.
INSTALLATION
i
MIN. 10cm
MIN. 30cm
Packaging
TRANSPORT
To Next Page
Loading...
