ZIRCON
21
WARNING!
Do not remove the steam wand from the jug
whilst the steam tap is open. Doing so may result
in scalding or serious injury.
Steaming
Frothing
02
03 04
05
01
OPERATION
Steaming and frothing milk
Place the steam wand over the drip tray
and open the steam tap for a few seconds,
this will allow condensed water to be
ejected. Close the steam tap when only
steam comes out.
Open the tap again to start heating or frothing the milk. Once the milk reaches the desired
temperature, close the tap and
remove the jug.
Immerse the steam wand into the jug containing the
milk, make sure the wand tip is submerged.
After the process is nished, position the steam wand
over the drip tray and open the steam tap for a few
seconds to clean leftovers of milk in the wand.
Close the tap and clean the outside of the steam wand
with a damp cloth to prevent nozzle blockage.