Need help?Do you have a question about the Extech Instruments HT200 and is the answer not in the manual?
General| Type | Infrared Thermometer |
|---|---|
| Temperature Resolution | 0.1°F/°C |
| Power Supply | 9V battery |
| Datalogging | No |
| Min/Max | Yes |
| Data Hold | Yes |
| Sensor Type | Infrared |
| Emissivity | Fixed at 0.95 |
| Response Time | 500ms |
| Display | LCD |
| Basic Accuracy | ±2% of reading |
| Resolution | 0.1°F / 0.1°C |
| Dew Point | Yes |
| Wet Bulb | Yes |
Indicates an active alarm condition on the meter.
Shows the current measurement mode, specifically WBGT.
Alerts the user when the device's battery is low.
Indicates the auto power off feature is enabled.
Instructions for turning the meter ON and OFF and checking firmware version.
Information about the automatic power off feature and how to enable/disable it.
How to enable and disable the audible and visual alarm functions.
Guide to selecting different measurement modes like WBGT, TA, %RH, TG, WET, DEW.
How to freeze and retain the current displayed reading.
Procedure for manually recording and storing current measurements.
How to access and scroll through stored measurement data.
How to track maximum and minimum recorded values.
How to set the upper limit for WBGT alarms.
How to set the lower limit for WBGT alarms.
Procedure for erasing all stored measurement data from the meter.
Instructions for adjusting the air temperature measurement offset.
Instructions for adjusting the relative humidity measurement offset.
Instructions for adjusting the black globe temperature measurement offset.
Guide for replacing the meter's 9V battery when the low battery icon appears.
Information about using the AC power adapter with the meter.
To Next Page