35
ROOM THERMOSTAT
Chapter 11
Thermostat with open contact D the stove switches o or stays o , and display D1 shows “STBY”.
This function can also be suspended temporarily by pressing button 1 for three seconds:
If the stove is in “ STBY” D phase, the stove remains o . Display D1 shows “STBY”, “ OFF” and the current
time.
If the stove is in “ T ON” D phase, the stove switches o . Display D1 shows “T ON”, “ OFF” and the current
time.
To return to using this function, press button 1 again.
To exclude this function altogether, just raise the stove thermostat temperature using button 3.
MECHANICAL THERMOSTAT OPERATION FOR HEAT DISTRIBUTION MOTOR
DIVINA PLUS ONLY
The connection of an external thermostat makes it possible to separate stove operation from the heat
distribution motor operation.
At this point you just have to set the desired temperature; the mechanical thermostat will control the
operation of the second motor:
If the temperature has not been reached yet, the second motor follows the operation of the stove.
Once the temperature has been reached, the stove takes the second motor to the 1st speed, and the
related indicator light on the control panel blinks.
ATTENTION!!!
Using an external environment thermostat in its various modalities, the day-night
temperature function is automatically disabled.
To Next Page
Loading...
