Extraflame Rosy - DAY;NIGHT TEMPERATURE FUNCTION

39
USER PARAMETERS
Chapter 12
Note: When the weekly programmer is on, the corresponding LED indicator on the control panel
is on (see description of indicator lights).
TO DISACTIVATE THE WEEKLY PROGRAMMER, enter the User Parameters by pressing button 3 and
holding it, then pressing button 5. Display D2 shows a blinking “0”. Use button 2 or 3 to set “OFF” mode on
display D1. Press button 1 to con rm and exit.
Manual controls via the front panel or remote control take precedence over any programmed settings.
DAY/NIGHT TEMPERATURE FUNCTION
The day/night temperature function makes it possible to switch the stove on/o automatically based on
two selected temperatures. This function is particularly useful when the stove heat exceeds the setting of
the room thermostat (e.g. due to mid-season temperatures or a stove that is oversized with respect to the
space).
This system enables you to select one temperature for daytime and one for night.
Firstly, it is necessary to set the current time using the current time regulation sequence in order to give a
time reference to the function itself.
To access the parameters of the day/night temperature function, press button 3 and hold it down, then
press button 5 and release both buttons at the same time. When you have entered the function, press
button 5 to move to parameter b (D2=B).
Parameter b (D2 = B, D1 =Ex. “06.00” )
Press button 2 or 3 to set the day period beginning/night period end.
Press button 5 to con rm and go to the next parameter.
Parameter c (D2 = C, D1 =Ex. “22.00” )
Press button 2 or 3 to set the day period end/night period beginning.
Press button 5 to con rm and go to the next parameter.
Parameter d (D2 = D, D1 =Ex. “25°C” )
Press button 2 or 3 to set the maximum temperature for the day period.
Press button 5 to con rm and go to the next parameter.
Parameter E (D2 = E, D1 =Ex. “20°C” )
Press button 2 or 3 to set the maximum temperature for the night period.
Press button 1 to con rm and exit.
When you have exited from the programming, to activate/disactivate the function, press button 4 and
hold it down, press button 5, then release both buttons at the same time.
The corresponding LED on the control panel will light up/go o (see description in the table of indicator
lights).
The various parameters must be set with the stove switched off!