Extreme Networks BlackDiamond 8806 - Connecting and Disconnecting Cables on the 8900-G96 T-C Module

BlackDiamond 8800 Series Switches Hardware Installation Guide
115
Figure 72: Connecting a 10G4Ca Module Port
To disconnect a cable from a 10G4Ca module:
1 Holding the cable connector with one hand, press it against the module front panel as you use the
other hand to pull back evenly on the latch (Figure 73).
Figure 73: Disconnecting a cable from a 10G4Ca port
2 Make sure the latch is pulled into the fully disengaged position.
3 Pull the cable connector straight off the port connector.
Connecting and Disconnecting Cables on the
8900-G96T-c Module
The ports on the 8900-G96T-c module use MRJ21 connectors. To connect these ports:
BD_158A