BlackDiamond 8800 Series Switches Hardware Installation Guide
155
Removing the PSU/Fan Controller
To remove a PSU/fan controller from the BlackDiamond 8800 series switch:
1 Attach the ESD-preventive wrist strap to your wrist and connect the metal end to the ground
receptacle on the front top-left corner of the switch.
2 Locate the eight captive screws on the PSU/fan controller access cover at the back of the
BlackDiamond 8800 series switch (see Figure 113 and Figure 114).
Figure 113: Removing the Access Cover from the BlackDiamond 8810 Switch
ASP032B
Loosen Captive
Screws (x8)
Remove PSU
Control Card
Access Panel
Cover
PSU Control
Card Access Panel
To Next Page
Loading...
