Extreme Networks BlackDiamond 8806 - Chapter 10: Blackdiamond PSU Covers; Required Tools; Blackdiamond 8806 PSU Cover

BlackDiamond 8800 Series Switches Hardware Installation Guide
139
10 BlackDiamond PSU Covers
Covers are available to mask the front panels of the installed power supplies in the BlackDiamond 8800
series switches.
This chapter includes the following sections:
● Required Tools on page 139
● BlackDiamond 8806 PSU Cover on page 139
● BlackDiamond 8810 PSU Cover on page 142
Required Tools
You need a #2 Phillips screwdriver to attach the power cord management bracket to the switch.
After the power cord management bracket is installed, you do not need any tools to attach the PSU
cover.
BlackDiamond 8806 PSU Cover
The BlackDiamond 8806 PSU cover fits onto the AC power cord management bracket and snaps into
place on the front of the BlackDiamond 8806 switch. The PSU cover kit includes the following parts
(Figure 96):
● PSU cover
● AC power cord management bracket with captive retaining screws
Figure 96: BlackDiamond 8806 PSU Cover Kit
EX_185