Extreme Networks BlackDiamond 8806 - Removing the Blackdiamond 8806 PSU Cover

BlackDiamond 8800 Series Switches Hardware Installation Guide
141
5 Push the top of the cover into place against the front of the switch until the latching tabs click into
place (Figure 99).
Figure 99: Latching the PSU Cover
Removing the BlackDiamond 8806 PSU Cover
To remove the PSU cover:
1 Press down on the latching tab at each side of the top.
2 With the latching tabs pressed down, pull outward on the top edge of the cover to disengage it from
the switch chassis.
3 Lift the cover off the AC cord retainer.
EX_188