Extreme Networks BlackDiamond 8806 - Installing the Blackdiamond 8806 PSU Cover

BlackDiamond PSU Covers
BlackDiamond 8800 Series Switches Hardware Installation Guide
140
Installing the BlackDiamond 8806 PSU Cover
To install the PSU cover:
1 If necessary, remove the installed AC cord retainer.
2 Make sure that all required AC power cords are connected to the AC input connectors on the switch.
3 Attach the AC power cord retainer to the switch:
a Place the retainer against the front of the switch as shown in Figure 97. Make sure that the
retainer engages all the power cord connectors.
b Align and tighten the captive retaining screws.
Figure 97: Attaching the AC Cord Retainer
4 Set the feet on the base of the cover into the square openings on the top of the AC cord retainer
(Figure 98).
Figure 98: Setting the PSU Cover in Place
EX_186
1
1 = Captive retaining screw
EX_187