BlackDiamond 8800 Series Switches Hardware Installation Guide
131
Figure 84: Inserting the Option Card
6 Release the hot-swap prevention latch and verify that the option card has engaged the alignment
pins and connector at the back of the card.
7 At the back of the option card, align and finger-tighten the captive retaining screws to secure the
card in place (Figure 85).
Figure 85: Securing the Option Card
8 Re-install the MSM, following the instructions in “Installing a BlackDiamond 8000 Series Module” on
page 111.
Leave the ESD-preventive wrist strap permanently connected to the switch so that it is always available
when you need to touch ESD-sensitive components.
Option card
MSM48c_hsp-latch
Option card
Tighten retaining
screws
MSM48cOptionCarda
To Next Page
Loading...
