BlackDiamond AC Power Cord Retainers
BlackDiamond 8800 Series Switches Hardware Installation Guide
134
3 Connect each AC power cord to a power outlet on the BlackDiamond 8810 switch as shown in
Figure 88.
Figure 88: Connecting an AC Power Cord to the BlackDiamond 8810 Switch
4 Make sure that each AC power cord is firmly plugged into the power outlet as shown in Figure 89.
Figure 89: AC Power Cord Plugged into the BlackDiamond 8810 Switch Power Outlet
5 Align the BlackDiamond 8810 AC power cord retainer over the AC power cord ends as shown in
Figure 90.
Figure 90: AC Power Cord Retainer Correctly Aligned
ASP009
ASP010
ASP012A
REMOVE TO INSTALL POWER CORDS
To Next Page
Loading...
