Extreme Networks BlackDiamond 8806 - Page 137

BlackDiamond 8800 Series Switches Hardware Installation Guide
137
3 Hold the AC power cord retainer as shown in Figure 93.
Figure 93: BlackDiamond 8806 AC Power Cord Retainer
4 Place the retainer against the switch as shown in Figure 94. Tighten the captive screw at each end of
the retainer.
Figure 94: Securing the BlackDiamond 8806 AC Power Cord Retainer
5 Starting from the left, lay the first four power cords into the retainer (see Figure 95).
6 Lay the last two power cords on top of the bottom four cords (see Figure 95).
EX_141
Captive screw
Captive screw
EX_139
Install and secure the channel bracket to
the switch by tightening both captive screws
Captive screw
Captive screw