Repacking a BlackDiamond 8800 Series Chassis
BlackDiamond 8800 Series Switches Hardware Installation Guide
162
8 Attach all four restraining bolts to the four shipping brackets, securing the BlackDiamond 8810
chassis to the shipping pallet (see Figure 117).
Figure 117: Recrating the BlackDiamond 8810 Chassis
9 Slide the shipping carton down over the BlackDiamond 8810 chassis.
10 Insert the clip locks (see Figure 118).
a Place your thumb and index finger inside the clip lock to grasp the prongs.
b Squeeze the prongs inward applying equal pressure on each side.
c Push the prongs inward until the clip lock is secured to the carton.
d Repeat these steps to insert each remaining clip lock.
Figure 118: Clip Locks on the BlackDiamond 8810 Shipping Carton
ASP016A
Install 4 bolts
securing chassis
to pallet
Slide carton
down over
chassis
EX_087B
Clip lock
Open
lock
Squeeze prongs
to unlock
To Next Page
Loading...
