Installing the BlackDiamond 8800 Series Chassis
BlackDiamond 8800 Series Switches Hardware Installation Guide
86
Figure 49: Removing Contents from the BlackDiamond 8810 Upper Shipping Carton
3 Release the clip locks as shown in Figure 45.
a Place your thumb and index finger inside the clip lock to grasp the prongs.
b Squeeze the prongs inward applying equal pressure on each side.
c Pull the prongs outward until the clip lock is released from the carton.
Repeat these steps to release each remaining clip lock.
Figure 50: Clip Locks on the BlackDiamond 8810 Shipping Carton
4 Lift the BlackDiamond 8810 shipping carton up and off the chassis (see Figure 51).
5 Remove all four restraining bolts that hold the BlackDiamond 8810 chassis to the shipping brackets
on the shipping pallet (see Figure 51).
ASP024
EX_087B
Clip lock
Open
lock
Squeeze prongs
to unlock
To Next Page
Loading...
