Extreme Networks ExtremeSwitching 210-12t-GE2 - Page 41

Mounting Two 12-Port Switches in a Rack Side by Side
The 12-port 210 and 220 switch models are constructed so that two of them can fit side by side into a
standard rack.
To mount two 12-port switches together in a rack, you will need the following equipment:
•
200-Series Dual Rack Mount Kit (separately orderable; part number 16572), which includes:
•
Two short mounting brackets
•
One long and two short middle-support brackets, for connecting the switches together
•
Twenty bracket screws
•
Standard rack-mounting hardware (not included)
•
Screws for the rack-mounting hardware (not included)
•
No. 1 Phillips screwdriver for attaching bracket hardware (a magnetic screwdriver is recommended)
•
Flat-head screwdriver for mounting the switches in the rack
The instructions in this section pertain to the following switch models:
•
ExtremeSwitching 210-12t-GE2 switch
•
ExtremeSwitching 210-12p-GE2 switch
•
ExtremeSwitching 220-12t-10GE2 switch
•
ExtremeSwitching 220-12p-10GE2 switch
To mount the switches, follow these steps.
1 Place both switches on a flat, stable surface.
Installing Your 210 or 220 Switch
ExtremeSwitching 210 and 220 Series Switches: Hardware Installation Guide 41