Procedure
1. Plug the female end of the AC power cord into the back of the switch power supply.
Important:
The switch powers on immediately when it is connected to a suitable AC power source.
The switch does not have a power switch.
2. Plug the male end of the AC power cord into a suitable AC power outlet.
Important:
Ensure you only use an appropriately rated AC power cord. Do not use an extension
cord.
Warning:
The only way to turn off the switch is to disconnect the power. Always connect the AC
power cord in a location that can be reached quickly and safely in case of an emergency.
Installation Preparation
February 2020 Installing Ethernet Routing Switch 3600 Series 22
To Next Page
Loading...
