Extreme Networks ExtremeSwitching 3600 Series - IP Address Information Configuration; Connecting a Console

Table 12: SFP+ transceiver Port LED state indicators
Label Color/Status Description
Tx Off No link established.
Solid Green SFP+ detected and link
established.
Green / blinking SFP+ link established and
transmit activity detected.
Solid Amber SFP detected and Link
established.
Amber / blinking SFP link established and
transmit activity detected.
Green / slow blinking RX & TX blinking together in a
slow pattern indicate that the
port has been disabled by the
software.
Rx Off No link established.
Solid Green SFP+ detected and link
established.
Green / blinking SFP+ link established and
receive activity detected.
Solid Amber SFP detected and link
established.
Amber / blinking SFP link established and
receive activity detected.
Green / slow blinking RX & TX blinking together in a
slow pattern indicate that the
port has been disabled by the
software.
IP Address Information Configuration
The following sections contain information necessary to configure IP address parameters on the
switch.
Connecting a Console
Before you begin
•
Terminal with AC power cord and keyboard
• Serial cable — a DB-9 to RJ-45 adapter or other suitable console cables can be used – the
maximum length of a console cable is 25 feet (8.3 meters)
IP Address Information Configuration
February 2020 Installing Ethernet Routing Switch 3600 Series 37