DXP HD 4K PLUS Series • Internal Web Page 96
Figure 56. Inputs Dialog Box
When finished viewing the input information, click the X in the upper-right corner of the
dialog box (see figure 56,
1
) to close it.
RS-232 Panel
The view-only RS-232 panel (see figure54,
3
, on page 93) displays the RS-232 protocol
for the DXP serial port. The defaults are:
• Baud rate — 9600
• Parity Bit — N (none)
• Data bits — 8
• Stop bits — 1
Device Status Panel
The Device Status panel (
4
) displays the current date, time, time zone, the amount of
time the device has been running (Uptime), and internal temperature in degrees Celsius.
Syncing the DXP 42 to the PC
To set the DXP 42 date and time to match that of your computer:
Click Sync to PC at the bottom of the Device Status panel. When the sync is completed,
the message shown in figure 57 appears in the upper-right corner of the screen.
Figure 57. Sync to PC Success Message
56
57
To Next Page
Loading...
