Extron electronics DXP HD 4K PLUS Series - DXP 42 Front Panel; Front Panel Features

DXP HD 4K PLUS Series • Operation 16
DXP 42 Front Panel
G
G
G
D
D
D
CONFIG
R
DXP 42 HD 4K PLUS
INPUTS
INPUTS
OUTPUTS
SIGNAL
HDCP
1 2 1 2
1234
3 4
JJJ
H
HH
A
A
A
B
B
B
C
C
C
III
A
Config port
H
HDCP LEDs
B
Input buttons
I
Reset button
C
Output buttons
J
Reset LED
G
Signal LEDs
Figure 9. DXP 42 HD 4K PLUS Front Panel
Front Panel Features
A
Config port (see figure8 on the previous page) — This USB mini-B port serves a
similar communications function to the rear panel Remote port, but is easier to access
than the rear port after the matrix switcher has been installed and cabled. Use a USB
type A to mini-B cable to connect this port to a USB connector on the computer
to enable SIS commands to be sent from the computer, connection to the PCS
configuration software, and uploading firmware.
NOTE: A front panel Config port connection and a rear panel Remote port
connection can both be active at the same time. If commands are sent
simultaneously to both ports, the command that reaches the DXP first is handled
first.
B
Input buttons — The input buttons have the following functions:
DXP 44, 84, and 88
• Primary:
• Select an input.
• Identify the selected input.
• Secondary: Save and recall presets (see Saving and Recalling Presets on
page25).
DXP 42
• Primary: Select an input.
• Secondary: View ties.
C
Output buttons — The output buttons have the following functions:
DXP 44, 84, and 88
• Primary:
• Select outputs.
• Identify the selected outputs.
9