Extron electronics DXP HD 4K PLUS Series - Symbol Definitions

DXP HD 4K PLUS Series • SIS Configuration and Control 43
Symbol Definitions
• = Space
]
= Carriage return with line feed
}
or |
= Carriage return with no line feed
E
or W
= Escape key
24
= Superscripts indicate the error message displayed if the command is entered
incorrectly or with invalid parameters (see Error Responses on page41).
X!
= Input number
0 = untie (for ties If applicable)
1 through <maximum number of inputs>
X@
= Output number
1 through <maximum number of outputs>:
DXP 42: 1 or 2
DXP 44 and 84: 1-4
DXP 88: 1-8
0 = untie (for ties if applicable)
X#
= Enable or disable
0 = disable
1 = enable
X$
= Name 16 alphanumeric characters (12 characters for room
names)
NOTE: The pipe (|) character cannot be used in names. All other characters, including
symbols and spaces, are permitted.
X%
= Analog audio and S/PDIF
output number
1 or 2
X^
= HDCP Authorized device
0 = block HDCP encryption
1 = allow HDCP encryption (default)
X&
= Input HDCP status
0 = no source detected
1 = source is HDCP compliant
2 = source is not HDCP compliant
X*
= Output format —
DXP 42
0 = auto (default)
1 = DVI RGB 4:4:4 Full
2 = HDMI RGB 4:4:4 Full
3 = HDMI RGB 4:4:4 Limited
4 = HDMI YUV 4:4:4 Full
5 = HDMI YUV 4:4:4 Limited
6 = HDMI YUV 4:2:2 Full
7 = HDMI YUV 4:2:2 Limited
Output format —
DXP 88, 84, and 44
0 = pass-through (default)
1 = RGB (color quantization follows input)
2 = YUV 444 (color quantization follows input)
3 = YUV 422 (color quantization follows input)
X(
= Color bit depth
0 = auto (default)
1 = 8-bit
X1)
= HDCP mode
0 = auto (follow the input, default)
1 = on (always encrypt HDMI outputs)