Extron electronics DXP HD 4K PLUS Series - Outputs Panel; Roles and Permissions Panel

DXP HD 4K PLUS Series • Internal Web Page 98
Outputs Panel
The Outputs panel (see figure54,
5
, on page 93) displays the resolution and refresh
rate of the outputs, their signal type (HDMI or DVI), and the HDCP status of all connected
outputs.
The following status symbols may be displayed for connected outputs:
Symbol Definition
The display is HDCP compliant.
The display is not HDCP compliant.
No Display
No display is connected.
Roles and Permissions Panel
In this panel (
6
) you can set and remove administrator and user passwords.
NOTE: The following rules apply to passwords:
• Length is 1-128 characters.
• All human-readable characters are permitted except
|
.
• The password cannot be a single space unless you are removing the password
entirely.
• Passwords are case-sensitive.
• A user password cannot be assigned if no administrator password exists.
• If the Admin password is cleared, the user password is cleared as well.
Setting a password
NOTE: The initial factory configured passwords for all accounts on this device have
been set to the device serial number. Passwords are case sensitive. In the event of an
absolute system reset, the passwords are reset to no password.
The web password is administrator level. Passwords are case sensitive.
To assign new administrator and user passwords:
1. In the Roles and Permissions panel, click Edit. The Role and Permission
Settings dialog box opens
2. In the Admin panel, click the Change Admin Password link and enter the new
administrator password in the field below (see figure60,
1
, on the next page).
3. Click in the Confirm Admin Password field (
2
) and repeat the password from the
Change Admin Password field.