Extron electronics DXP HD 4K PLUS Series - Page 17

DXP HD 4K PLUS Series • Installation 9
F
LAN port — Connect the DXP switcher to a computer, a network switch, or
a control system via this RJ-45 connector (see figure3,
E
, on page 7, or figure4,
E
,
on the previous page). You can use a computer to configure and control the networked
switcher with SIS commands, the PCS configuration software, or the HTML page that is
embedded on the switcher (see Connecting to the LAN Port on page10).
Ethernet connection indicators — The green and amber LEDs on the
LAN connector indicate the status of the Ethernet connection. The green
(link) LED indicates that the switcher is properly connected to an Ethernet
LAN. This LED should light steadily. The amber (activity) LED indicates
transmission of data packets on the RJ-45 connector. This LED should flicker as the
switcher communicates.
The default Ethernet settings are:
IP address — 192.168.254.254
Subnet mask — 255.255.0.0
Gateway address — 0.0.0.0
G
Analog audio outputs — Connect powered speakers, an amplifier, or other audio
output device to these 5-pole 3.5 mm captive screw connectors for 2-channel stereo
analog audio output. These connectors can de-embed LPCM audio that was routed
from any DXP HDMI input and convert it to a stereo analog signal.
NOTE: Analog output 1 and S/PDIF output 1 are always connected to the video
input tied to them. Analog and S/PDIF output 2 can be broken away (switched
separately from the video).
Figure 5 shows how to wire these connectors. Use the supplied tie-wrap to strap the
audio cable to the extended tail of the connector.
Do not tin the wires!
Balanced Audio Output
Tip
Ring
Tip
Ring
Slee
ves
Unbalanced Audio Output
Tip
No Ground Here
No Ground Here
Tip
Sleeves
LR
LR
Figure 5. Wiring the Captive Screw Analog Audio Output Connectors
ATTENTION:
• For unbalanced audio, connect the sleeves to the ground contact. DO NOT
connect the sleeves to the negative (-) contacts.
• Pour l’audio asymétrique, connectez les manchons au contact au sol. Ne PAS
connecter les manchons aux contacts négatifs (–).
NOTE: The length of exposed wires is important. The ideal length is 3/16 inch
(5 mm).
LAN
5