Extron electronics DXP HD 4K PLUS Series - Page 71

DXP HD 4K PLUS Series • SIS Configuration and Control 63
Command ASCII Command
(Host to Switcher)
Response
(Switcher to Host)
Additional Description
Serial Port Configuration
Set serial port parameters
EX4%*X4^,X4&,X4*,X4(CP}
CpnX4%•CcpX4^,X4&,X4*,X4(]
Set the baud rate, parity, data
bits, and stop bits for serial
port X4%.
View port parameters
EX4%CP} X4^,X4&,X4*,X4(]
MKP Mode for Volume Control
Set the MKP mode
EX5$SVOL} SvolX5$]
Set the number of volume
steps (MKP mode) to X5$.
View the MKP mode
ESVOL} X5$]
View the current MKP mode
setting.
KEY:
X4% = Port number
01 – 99
X4^ = Baud rate
9600 (default), 19200, 38400, 115200
X4& = Parity
Odd, Even, None (default), Mark, Space
Enter only the first letter.
X4* = Data bits
7, 8 (default)
X4( = Stop bits
1 (default), 2
X5$ = MKP mode
Volume steps:
1 = Set DXP to normal operation, 1-100 steps (default).
2 = Set DXP to MKP volume control range, 1-64 steps.
NOTES:
• Entering the E ZQQQ} or E ZXXX} system reset command resets the MKP mode to the factory
default (mode 1).
• Affects all analog and S/PDIF audio outputs.