Extron electronics DXP HD 4K PLUS Series - Configuration Software

DXP HD 4K PLUS Series • SIS Configuration and Control 71
Command ASCII Command
(Host to Switcher)
Response
(Switcher to Host)
Additional Description
Device Commands (continued)
Reset Commands
Reset all device settings to
factory default
24
EZXXX} Zpx]
Reset all device settings
to factory default except
unit name.
Absolute system reset
24
EZQQQ} Zpq]
Reset all device settings,
including DHCP (off) and
IP settings. The default
IP address after reset is
192.168.254.254.
NOTE: Entering this command or performing a mode 5 reset via the rear panel Reset button (see the Reset
Modes Summary on page34) removes the current passwords (whether user-set or the factory-set
serial number), leaving the unit with no password.
IP system reset
E1ZQQQ} Zpq1]
Resets IP settings such as
IP address, subnet mask,
gateway IP address, unit
name, DHCP setting and
port mapping (telnet,
web, or direct access)
to factory defaults, and
restarts the network.
NOTE: This command includes the 2BOOT} command so a separate 2BOOT} command is not required.
The Zpq1] response is followed by Reconfig] and Boot2] responses.
Reset all device settings and
delete files
24
EZY} Zpy]
Reset all device settings,
excluding IP settings.
Information Requests
General information
I
VX! XX@
•
AX! XX%]
Verbose modes 2 and 3:
Info00*VX! XX@
•
AX! XX%]
View the number of inputs
and outputs for video and
audio connectors.
NOTE: VX! XX@ is the video matrix size. AX! XX% is the audio matrix size.
KEY:
X! = Input number
1 through 4
X@ = Output number
HDMI output, 1 through <maximum number of outputs>:
DXP 42 — 1 or 2, DXP 44 and 84 — 1-4, DXP 88 — 1-8
X% = Analog audio output number
1 through 4