Extron electronics ISM 824 - Command;Response Table for SIS Commands (Continued)

SIS
™
Programming and Control, cont’d
ISM 824 Integration Scaling Multiswitcher • SIS
™
Programming and Control
4-14
Command/response table for SIS commands (continued)
Command ASCII (Telnet)
(host to switcher)
URL Encoded (Web) (host to switcher)
Response (switcher to host)
Additional description
Resets
Reset an individual I/O preset
Esc X4(ZG} WX4( ZG|
Zpg
X4(]
Clear global I/O preset
X4(.
Reset all I/O presets
Esc ZG} WZG|
Zpg00
]
Clear all global I/O preset.
Reset audio input levels
Esc ZA} W ZA|
Zpa
]
Reset all audio input levels (gain and attenuation) to 0 dB.
Reset all mutes
Esc ZZ} WZZ|
Zpz
]
Reset all video and audio mutes.
System reset
Esc ZXXX} W ZXXX|
Zpx
]
Reset factory defaults.
Individual board reset
Esc X5) ZX} W X5) ZX|
Zpx
X5)]
Reset individual card.
Universal Scaler (ISM RGB) Output
Input sampling
Horizontal start
Specify a value
X@*X$ )
X@
%2AX$ ) X@
Hst
X!*X$]
Specify the horizontal location of first active pixel.
Increment value
X@+)
X@
+) X@
Hst
X!*X$]
Increase the value.
Decrement value
X@-)
X@
-) X@
Hst
X!*X$]
Decrease the value.
View
X@)
X@
) X$]
Show the horizontal location of first active pixel.
Vertical start
Specify a value
X@*X% (
X@
%2AX% ( X@
Vst
X!*X%]
Specify the vertical location of first active line.
Increment value
X@+(
X@
+( X@
Vst
X!*X%]
Increase the value.
Decrement value
X@-(
X@
-( X@
Vst
X!*X%]
Decrease the value.
View
X@(
X@
( X%]
Show the vertical location of first active line.
Pixel phase (available only for RGB, YUV-HD, and YUVp input signals)
Specify a value
X@*X^ U
X@%2AX^ U X@
Phs
X!*X^]
Adjust the pixel phase to a specified value.
Increment value
X@+U X@+U X@
Phs
X!*X^]
Increase the value.
Decrement value
X@-U X@-U X@
Phs
X!*X^]
Decrease the value.
View
X@U X@U X^]
Show the pixel phase.
Total pixels (available only for RGB, YUV-HD, and YUVp input signals)
Specify a value
11*
X@*X& #
11%2A
X@%2AX& # X@
Tpx
X!*X&]
Adjust the total pixels to a specified value.
Increment value
11*
X@+# 11%2AX@+# X@
Tpx
X!*X&]
Increase the value.
Decrement value
11*
X@-# 11%2AX@-# X@
Tpx
X!*X&]
Decrease the value.
View
11*
X@# 11%2AX@# X&]
Show the total pixels.