Dokument-Nr.: 01.1411.010.71e / Revision: 3.00
2.7 Transmission
By pushing the PTT button, the device starts transmission on the active
frequency. The operation of the transmission is indicated by “TX” in front
of the frequency used.
ACT
In order to avoid unintended transmissions, e.g. when having the PTT
button stuck (“stuck mic”), the transmitter automatically stops after two
minutes of transmission, and „TX“ is substituted by „Te“.
In order to re-enable transmission, release PTT and push it again.
2.8 Reception
When receiving, a „RX“ is shown in front of the active frequency. When
having dual watch active (see 2.6) this can be on the standby frequency,
too.
ACT
To Next Page
Loading...
